Disassembly Of Cd Illumination P.c.b - Technics SU-C500EB Service Manual

Step 2 Remove Mecha Chassis & Floating Springs.
Caution : Keep the Floating Springs in safe place and place
them back during assembling.
Step 3 Remove 2 screws.
Step 4 Desolder points on the solder side of the CD P.C.B..
Step 5 Lift up the Connector Cover.
Caution : Do not use strong force as it may damage the
connector cover.
Step 6 Detach 24P FFC at the connector (CN7003) on CD
P.C.B..Step 5 Lift up the Connector Cover.
Step 7 Remove CD P.C.B..
Step 8 Attach short pin to the 24P FFC of the Traverse Unit.
8.21. Disassembly of CD Illumination
P.C.B.
• Refer to "Disassembly of Rear Panel".
• Refer to "Disassembly of Side AL Panel L & R".
• Refer to "Disassembly of Bottom Chassis".
• Refer to "Disassembly of Front Panel Block".
• Refer to "Disassembly of SMPS P.C.B.".
• Refer to "Disassembly of AMP P.C.B.".
• Refer to "Disassembly of CD Mechanism Block".
Step 1 Remove 2 screws.
Step 2 Detach 4P FFC at the connector (P7003) on Main
P.C.B..
Step 3 Remove CD Illumination P.C.B..
54