Settings In The "Tcu.ini" File - Siemens SINUMERIK 840D sl Equipment Manual

General information and networking
4.3 Networking
Note
Connecting an MCP via PROFIBUS
If an MCP is connected via PROFIBUS, then the MCP Index = 0 should be set.
Compatibility of software versions
If a "config" file is available for the TCU, the data file structures of older versions are transferred
to the config.ini file and the data file structure is then deleted.
Comment
In the config.ini file comment lines are indicated by the # character preceding a line.
4.3.2.8

Settings in the "TCU.ini" file

Directories
The tcu.ini files is created in the following directories:
NCU:
PCU (Windows XP):
PCU (Windows 7):
Note
Only the following entries are evaluated by SINUMERIK Operate:
• VNCServer/VetoMode
• VNCServer/AlarmBoxTimeOut
• VNCServer/FocusTimeout
• VNCServer/AdaptResolution
• VNCServer/MaxActiveTCUs
• VNCViewer/ExternalViewerSecurityPolicy
Structure and content
In the tcu.ini file comment lines are indicated by the # character preceding a line.
66
/siemens/system/etc/tcu.ini
/user/system/etc/tcu.ini
/oem/system/etc/tcu.ini
F:\addon_base\system\etc\tcu.ini
F:\user_base\system\etc\tcu.ini
F:\oem_base\system\etc\tcu.ini
C:\ProgramData\Siemens\MotionControl\siemens\Syste
m\etc\tcu.ini
C:\ProgramData\Siemens\MotionControl\user\System\e
tc\tcu.ini
C:\ProgramData\Siemens\MotionControl\oem\System\et
c\tcu.ini
Handheld Terminal HT 8
Equipment Manual, 02/2024, A5E52918633B AA