Electrolux ESM48311SX User Manual page 21

Table of Contents

Advertisement

Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with wa‐
ter.
The display shows i10 or i11.
The appliance does not drain the
water.
The display shows i20.
The anti-flood device is on.
The display shows i30.
The appliance stops and starts
more times during operation.
The programme lasts too long.
The displayed programme duration
is different than the duration in the
consumption values table.
The remaining time in the display in‐
creases and skips nearly to the end
of programme time.
Small leak from the appliance door.
The appliance door is difficult to
close.
The appliance door opens during
the wash cycle.
Rattling/knocking sounds from in‐
side the appliance.
Possible cause and solution
Make sure that the mains plug is connected to the mains socket.
Make sure that there is no damaged fuse in the fuse box.
Make sure that the appliance door is closed.
Press the start button.
If the delay start is set, cancel the setting or wait for the end of the
countdown.
The appliance recharges the resin inside the water softener. The dura‐
tion of the procedure is approximately 5 minutes.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too low. For this
information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
Make sure that the sink spigot is not clogged.
Make sure that the interior filter system is not clogged.
Make sure that the drain hose has no kinks or bends.
Close the water tap.
Make sure that the appliance is correctly installed.
Make sure the baskets are loaded as instructed in the user manual.
It is normal. It provides optimal cleaning results and energy savings.
If the delayed start is set, cancel the delay setting or wait for the end of
the countdown.
The pressure and the temperature of the water, the variations of the
mains supply, the options, the quantity of dishes and the degree of soil
can change the programme duration.
This is not a defect. The appliance is working correctly.
The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
The appliance door is not centred on the tub. Adjust the rear foot (if ap‐
plicable).
The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
Parts of the tableware are protruding from the baskets.
The AirDry function is activated. You can deactivate the function. Refer
to "Settings".
The tableware is not properly arranged in the baskets. Refer to basket
loading leaflet.
Make sure that the spray arms can rotate freely.
ENGLISH
21

Advertisement

Table of Contents
loading

Table of Contents