Malfunction
Condensation water in it
condensation water tank
voir, although the water
drain hose is connected
locks.
Program does not start.
The program duration
changes during
drying.
Pump sound.
Buzzing sound.
Drying time is too long.
Cause and Troubleshooting
The device uses condensed water for automatic self-
cleaning.
No error - no action required.
▶
Water drain hose is not connected correctly.
Make sure that the water drain hose is correctly
▶
connected.
→ "Connect the water drain hose", page 14
Child lock is activated.
→
"Deactivate childproof lock", page 34
▶
Start/Pausewas not pressed.
Press
Start/Pause .
▶
No program set.
→ "Set program", page 30 .
1.
→ "Starting the program", page 30 .
2.
The program sequence is optimized electronically. This
may lead to changes in the program duration.
No error - no action required.
▶
Condensation water pump active.
No error - normal operating noise.
▶
Compressor vent active.
No error - normal operating noise.
▶
Fluff filter is dirty.
→ "Clean the fluff filter", page 31
▶
Ambient temperature is higher than 30°C.
Make sure the ambient temperature is below 30°C.
▶
Ambient temperature is lower than 15°C.
Make sure that the ambient temperature is above
▶
15 °C.
Insufficient air circulation at the installation site of
the device.
Ventilate the installation site of the device.
▶
Ventilation opening of the device is blocked.
Make sure that the ventilation opening of the device
▶
is kept clear.
Heat exchanger is contaminated.
TroubleshootingNL
43