Table of Contents
Advertisement
Installation
VIEWED FROM SOLDER SIDE
Assembly Procedure:
1. ()
Insert approximately 10 inches of cable (item 10) into
the connector hood (item 1).
2. ()
Strip the outer jacket of the cable back 5 inches.
3. ()
Remove approximately 1/4-inch of insulation from
each signal wire.
4. ()
Starting at the end of the 30-pin connector (item 7)
nearest pins Sand 15, solder the signal wires to the
appropriate pins on the connector, and insulate each
pin with tubing as shown at left.
5. ()
Install the 30-pin connector in the connector hood
using the two self-tapping screws (items 2 and 4).
6. ()
Install the cable clamp (items 3 and 8), and tighten it
in place with the screw and nut (items 5 and 6).
7. ()
Tighten the cable clamp on the cable with the
setscrew (item 9).
Figure 7-28. Assembling the PCA Hood Connector
7-36
Advertisement
Table of Contents
