Configure the system
Complete the following procedures to configure the system. For detailed instructions, refer to
"System configuration" on page
1. Set the network connection for the Lenovo XClarity Controller to the management network.
2. Update the firmware for the system, if necessary.
3. Configure the firmware for the system.
The following information is available for RAID configuration:
•
https://lenovopress.lenovo.com/lp0578-lenovo-raid-introduction
•
https://lenovopress.lenovo.com/lp0579-lenovo-raid-management-tools-and-resources
4. Install the operating system.
5. Back up the system configuration.
6. Install the applications and programs for which the system is intended to be used.
53.
Chapter 5
.
Chapter 4
Unboxing and setup
51