Winding The Tape - Yamaha GX-50 Owner's Manual

TAPE DECK OPERATION
Direct operation
When the power is off (in the standby mode), pressing the
TAPE 1/2 input selector button or the play button will turn the
power on and start playback of the selected tape
automatically.
When the power is on, even if an input source other than tape
deck is selected, pressing the play button (or the fast wind
button) will start playback (or fast winding) directly.
MINI COMPONENT SYSTEM
GX–50
1
2
3
LOCATION
MUSIC
BAND
USER MEMORY
MODE
DOLBY NR
POWER
PHONES
AUTO/MAN'L
TIMER
HOUR
PLAYBACK
EJECT
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE REPEAT
DISC SKIP
LOCATION
MUSIC
USER
SLEEP
DISC CHANGE
OPEN/CLOSE
VOLUME
CD
DOWN UP
TUNER AUX
TAPE 1/2
REC/PAUSE
NORMAL
HIGH
DUBBING
TIMER REC
MEMORY
Active Servo
Technology
TIME ADJ
MIN
1 2
REC/PLAYBACK
EJECT
CD
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
TAPE EDIT I0
RANDOM OPEN/CLOSE TUNER
STOP PLAY/PAUSE
PLAY STOP PLAY
TAPE
FLAT REC/PAUSE DECK 1/2
POWER
INPUT
VOLUME
Notes
•
When removing the tape, press the stop
then open the cassette compartment.
•
Even if you press the TAPE 1/2 input selector button on
the front panel or the DECK 1/2 button on the remote
control transmitter during playback, the playback of
currently selected tape cannot be changed to the other
one though the tape number indicator on the display
changes.

Winding the tape

1
If during playback, first press the stop
2
Next press the fast wind
wind the tape.
3
Press the stop
Note
When the tape is wound to the end, this unit will then function
as described below, according to the setting of the reverse
MODE selector button.
: The tape stops at the end.
: When the tape reaches the end, playback
automatically starts from the reverse side.
Searching for the beginning of a
desired selection
Carry out the following operation during playback to find the
beginning of a desired selection on the tape.
To listen to the same selection
Press the button if the direction of the current playback
is .
Press the button if the direction of the current playback
is .
To listen to the next selection
Press the button if the direction of the current playback
is .
Press the button if the direction of the current playback
is .
Notes
•
This function may not work for tapes with
* Material with long pauses or quiet passages.
* Low recording levels or excessive noise.
* Pauses of less than 4 seconds between selections.
•
If searching is carried out at the first or the last part of a
selection, the desired selection may not be found.
E-26
button, and
button.
or fast wind
Moves rapidly in the direction of the
current playback while searching.
button to stop.
Flashes on and off.
Moves rapidly in the direction of the
current playback while searching.
button to