Table of Contents
Advertisement
Important!
Auto Light may not operate properly
●
when the watch is at a horizontal angle
of 15 degrees or greater from
horizontal as shown in the illustration
below.
Auto Light may operate unintentionally
●
and run down the battery if the watch
is blocked from light by your sleeve.
Electro-static charge or magnetism
●
can interfere with proper auto light
operation. If this happens, try lowering
your arm and then angle it towards
your face again.
When moving the watch you may note
●
a slight rattling sound. This is due to
operation of the auto light switch,
which determines the current
orientation of the watch. It does not
indicate malfunction.
Note
Auto Light is disabled when any one of
●
the conditions below exists.
Alarm, timer alert, or other beeper
ー
sounding
Time calibration reception in
ー
progress
Configuring the Auto Light Setting
●
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (B) for at least three seconds
to toggle Auto Light between enabled and
disabled.
[LT] is displayed while Auto Light is
●
enabled.
On
Note
Auto Light is disabled while [CHG] is
●
shown on the display.
Watch Operation Guide 3495
Specifying the Illumination Duration
●
You can select either 1.5 seconds or three
seconds as the illumination duration.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3.
Press (C) 12 times.
This will cause [1] or [3] to appear on the
display.
4.
Press (D) to toggle between the two
illumination duration settings.
[1]: 1.5-second illumination
[3]: 3-second illumination
5.
Press (A) to complete the setting
operation.
Time Adjustment
Your watch can receive time calibration
signals and adjust its date and time setting.
Home City
Time Adjustment Using a
Time Signal
Overview
The watch's time and day settings can be
configured in accordance with a received time
calibration signal.
Important!
In order to make it possible for the
●
current time setting to be adjusted
correctly based on time calibration
signal reception, you need to specify
the area where you are using the
watch.
Setting a Home City
l
Note
Areas where time signal reception is
●
supported are limited. When you are
using the watch in an area where time
calibration signal reception is not
possible, adjust time and day settings
manually.
Using Watch Operations to Adjust
l
the Time Setting
8
Advertisement
Table of Contents
