Using Watch Operations To Adjust The Time Setting - Casio GW-M5610U Operation Manual

Using Watch Operations to
Adjust the Time Setting
If, for some reason, you cannot use time signal
reception to adjust the current time setting,
you can adjust date, time, and Home City
settings manually using watch button
operations.
Setting a Home City
●
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area that observes summer time, you can also
configure a summer time setting.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3.
Use (B) and (D) to change the Home City
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
For details refer to the information
●
below.
City Table
l
4.
Press (C).
5.
Use (D) to select a summer time setting.
Each press of (D) cycles through available
settings in the sequence shown below.
[AUTO]
●
The watch switches between standard
time and summer time automatically.
[OFF]
●
The watch always indicates standard
time.
[ON]
●
The watch always indicates summer
time.
6.
Press (A) to complete the setting
operation.
Watch Operation Guide 3495
Note
The [AUTO] summer time setting is
●
valid only when the watch's Home City
is in an area where a time signal can be
received.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Setting the Time/Date
●
You can use the procedure below to adjust the
time and date settings when using the watch
where signal reception is not possible.
Important!
If you are using the watch in an area
●
where signal receive operations are
possible, time and date settings using
Home City
the time signal is recommended.
Configure the Home Time setting
●
before changing the current time and
date settings.
Setting a Home City
l
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3.
Keep pressing (C) until the setting you
want to change is flashing.
Each press of (C) moves the flashing to
●
the next setting in the sequence shown
below.
Home City
Operation tone enable/disable
Home City
Summer time
Seconds
Hours
Minutes
Year
Month
Day
12/24-hour timekeeping
Date display format
Day of the week language
Illumination duration
Auto Receive
Power Saving
11