Controls, Indicators, And Connectors; Volume Control; Frequency Display - Kenwood KR-930 Instruction Manual

Controls, indicators and connectors
© 6 60 86 ©
8
VOLUME CONTROL
ON OOFF
Loupness *°
SPEAKER A
@ POWER switch
Push it to turn on power.
Push it again to turn power off.
@ FREQUENCY DISPLAY
The frequency being received is indicated by this digital dis-
play.
® SIGNAL indicator
The 3-LED indicator lights to show the strength of incoming
signal. The number of LEDs that light is proportional to the
signal strength. Tune so that most LEDs light.
@ STEREO indicator
Lights to show that the selected FM channel is transmitting
in stereo and that the signal is strong enough to overcome
muting.
@® TUNED indicator
Lights to show when an FM or AM station is received.
@ MEMORY indicator
When the MEMORY button is pressed, the indicator lights
for approx. five seconds. Press the PRESET STATION button
while this indicator lights to store the desired station.
@ POWER LEVEL indicator
The POWER LEVEL indicator is for both the left and right
channels. The indicator is calibrated for an 8-ohm load. (f
4-ohm speakers are used, multiply the reading by 2, for
16-ohm speakers, divide the reading by 2.
@ LOUDNESS switch
This switch boosts bass response to compensate for the
lack of response in human hearing to those frequencies at
low volume levels. This switch should be switched off when
listening at normal and high levels.
6 KR-930 (k}
AUT.
(O tn 4
Brace tustony
'TAPE DUBBING Boa
L—— TAPE SELECTOR
© VOLUME CONTROL
This control adjusts left-and right-channel volume simultan-
eously. Set it for the desired listening level.
@ SPEAKER A and B switches
A ON - Activates speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON - Activates the speakers connected to the SPEAKERS
B terminals on the rear panel.
A, B ON - Activates the speakers connected to the
SPEAKERS A and B terminals simultaneously.
Note:
When the SPEAKER A and B switches are used at the same time,
the speakers connected to the SPEAKERS A and B terminals are
connected in series. tn this respect, whenever using the SPEAKER
A and B switches at the same time, be sure that two pairs of
speakers are connected to the terminals A and B, otherwise no
sound is output.
@ PHONES jack
Stereo headphones are plugged into this jack. When
SPEAKER A and B switches are set to OFF, only head-
phones can be heard.
@® PRESET STATION buttons
These buttons are used to preset the frequencies of broad-
casting stations. Each button gives access to two memory
sections, one for the FM band and the other for the AM
band. As a result, one FM frequency and one AM frequency
can be preset with one preset vutton. Selection between
FM and AM is performed witis the INPUT SELECTOR
switches.
With this preset function, preset tuning is available without
pressing the UP or DOWN switch.