Adjustment Before Operation - Yamaha DSP-E200 Owner's Manual

ADJUSTMENT BEFORE OPERATION

SPEAKER BALANCE ADJUSTMENT
Using the built-in test tone generator, this procedure lets you adjust the sound output level balance between the front, center, and
rear speakers. With this adjustment, the sound output level heard at the listening position will be the same from each speaker.
This is important for the best performance of digital sound field processor.
The adjustment of each speaker output level should be done at your listening position with the remote control transmitter.
Otherwise, the result may not be satisfactory.
2
1
Set to the "
2
Set on the POWER of this unit and the amplifier etc.
3
DIGITAL SOUND FIELD PROCESSING
CONCERT
PRO LOGIC ENHANCED
VIDEO
DOLBY SUR.
3
54
VOLUME
0
— dB
∞
" position.
POWER
MONO ROCK CONCERT
OFF
MOVIE CONCERT HALL
1
4
Select the center mode depending on your speaker
configuration.
(Refer to "SPEAKER CONFIGURATION" on page 5.)
NORMAL
WIDE
PHANTOM
On the feature of each mode, refer to the "Note" shown
below.
5
TEST
Note
In step 4, when you select the center mode, note the following.
For 5 speaker configuration)
NORMAL: Select this mode when you use the center speaker
smaller sized than the front speakers. In this mode,
the bass tone will be output from the front
speakers.
WIDE: Select this mode when you use the center speaker
approximately same sized as the front speakers.
For 4 speaker configuration)
PHANTOM: Select this mode when you do not use the center
speaker. The center sound will be output from the
left and the right front speakers.
CENTER
MODE
ms
DELAY
TEST
F C R
PRO LOGIC CONCERT MONO ROCK CONCERT PRO LOGIC CONCERT MONO ROCK CONCERT
ENHANCED VIDEO MOVIE CONCERT HALL
Flashes on and off continuously.
NORMAL
11