Troubleshooting - Electrolux HHOB875S User Manual

2. Clean the hood cavity with a cleaning
foam.
3. Wash the filter and filter housing
manually in warm water without using
detergents or abrasive sponges. You
can also wash them in a dishwasher
with the maximum temperature of
65-70 °C, without detergents and
without dishes in the same load. Only
the plastic parts can be cleaned
using detergents.
4. Dry the filter for 7 minutes in an oven
with the maximum temperature of
60°C or in an ambient temperature.

9. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
You cannot activate or
operate the hob.
5. Fix the filter and filter housing back in
6. Reset the counter.
Resetting the counter when the filter
indicator is on:
1. Clean the filter first and place it back
2. Press
Resetting the counter before the filter
indicator appears:
1. Make sure the hob is switched off
2. Clean the filter and place it back
3. Press
The counter starts automatically when
you turn on the hood for the first time.
The maximum number of cleaning cycles
is 8. After that time, the filter needs to be
replaced with a new one.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
You do not set the heat
setting for 60 seconds.
place when they are fully dried.
inside the hood.
briefly, while the indicator is
blinking. The counter restarts.
and Child Safety Device does not
operate.
inside the hood.
twice. The indicator
appears and the signal sounds. The
counter restarts.
WARNING!
An oversaturated filter can
pose a risk of fire.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Activate the hob again and
set the heat setting in less
than 60 seconds.
ENGLISH 21