Cub Cadet 5000 Series Operator's Manual page 29

Series 5000
Hide thumbs Also See for 5000 Series:
Table of Contents

Advertisement

BATTERY REMOVAL
WARNING: Battery posts, terminals
and related accessories contain lead
and lead compounds. Wash hands
after handling.
The battery is located at the front of the tractor
beneath the hood.
To remove the battery:
Open the tractor hood as described in the
previous sub-section.
Remove the two wing nuts and the battery
holddown strap from the battery holddown rods.
See Figure 34.
Spread the locking clips on the sides of the
terminal covers and lift the tops of the covers to
expose the battery connections. See Figure 34.
Loosen the cable clamp of the black negative
battery lead, then lift the negative cable and its
terminal cover off the negative battery post
(marked NEG). Move the cable away from the
negative battery post.
Repeat the above procedure to remove the
cable and cover from the positive battery post
(marked POS).
Carefully lift the battery out of the tractor.
Install the battery by repeating the above steps in
the reverse order.
WARNING: Always connect the posi-
tive lead to the battery before con-
necting the negative lead. This will pre-
vent sparking or possible injury from
an electrical short caused by contact-
ing the tractor body with tools being
used to connect the cables.
HOLDDOWN STRAP
WING NUT
BATTERY
HOLDDOWN
ROD
Figure 34
CHARGING THE BATTERY
Test and, if necessary, recharge the battery after
the tractor has been stored for a period of time.
Voltmeter
Reading
BATTERY MAINTENANCE
The battery is filled with battery acid and then
sealed
"maintenance
maintenance to ensure its proper life cycle.
BATTERY STORAGE
CABLE
CLAMP
TERMINAL
COVER
29
A voltmeter or load tester should read 12.6 volts
(DC) or higher across the battery terminals.
Charge the battery with a 12-volt battery
charger at a MAXIMUM rate of 10 amps.
State of
Charge
12.7
100%
12.4
75%
12.2
50%
12.0
25%
at
the
factory.
free"
battery
Spray the terminals and exposed wire with a
battery terminal sealer, or coat the terminals
with a thin coat of grease or petroleum jelly, to
protect against corrosion.
Always keep the battery cables and terminals
clean and free of corrosion.
Always keep the terminal covers in place and
closed over the battery terminals.
Avoid tipping. Even a sealed battery will leak
electrolyte when tipped.
When storing the tractor for extended periods,
disconnect the negative battery cable. It is not
necessary to remove the battery.
All batteries discharge during storage. Keep the
exterior of the battery clean, especially the top.
A dirty battery will discharge more rapidly.
The battery must be stored with a full charge. A
discharged battery can freeze sooner than a
charged battery. A fully charged battery will
store longer in cold temperatures than hot.
Recharge the battery before returning to service.
Although the tractor may start, the engine charg-
ing system may not fully recharge the battery.
Charging
Time
Full Charge
90 Min.
180 Min.
280 Min.
However,
even
a
requires
some

Advertisement

Table of Contents
loading

This manual is also suitable for:

5254

Table of Contents