Yaesu VL-1000 Operating Manual page 12

Metering
An extensive array of metering selections
are available to the owner of the VL-1000.
Pressing the DISPLAY SELECT switch allows
you to choose from among these options.
There are also two "Display Memory" switches
on the front panel of the VL-1000, which you
may use to store and recall your most-used
metering choices. To store a meter selection,
press and hold in for ½ second the DISPLAY
1 (or DISPLAY 2) switch until you hear a double
beep. To recall the saved setting, just touch
(momentarily) the DISPLAY 1 (or DISPLAY
2) switch.
Multi Meter 1:
Peak and Average Power Output Bar Graphs
Peak and Average Power Output Numeric
Displays
PA Drain Current Bar Graph
PA Drain Voltage Bar Graph
Current T /R Status
X X
SWR Numeric Display
Current Frequency Band (Numeric Display)
Multi Meter 2:
Peak and Average Power Output Bar Graphs
Peak and Average Power Output Numeric
Displays
PA Drain Current Bar Graph
Current T /R Status
X X
SWR Bar Graph
SWR Numeric Display
Current Frequency Band (Numeric Display)
PO Meter 1:
Peak and Average Power Output Bar Graphs
with Peak-hold Segment
Peak and Average Power Output Numeric
Displays
SWR Numeric Display
Current T /R Status
X X
Current Frequency Band (Numeric Display)
VL-1000 Operating Manual
PO Meter 2:
Peak Power Output Bar Graph (large) with
Peak-hold Segment
Peak and Average Power Output Numeric
Displays
SWR Numeric Display
Current T /R Status
X X
Current Frequency Band (Numeric Display)
Antenna Tuning Meter:
Current (changing) SWR Bar Graph
Pictorial display of relative positions of An-
tenna Tuner Variable Capacitors
Current Frequency Band (Numeric Display)
Graphical SWR Meter:
Current Antenna Jack in Use (ANT 1 ~ ANT 4)
Display of "T O
UNER
Display of "T
UNER
Graph, this indicator does not indicate when
SWR is above 1.5:1.)
Current Frequency Band (Numeric Display)
User-Defined Span on Band Display
1.8 ~ 14 MHz: 100/500/1000 kHz (selectable)
14 ~ 28 MHz: 500/1000 kHz (selectable)
28 ~ 54 MHz: 1000 kHz (fixed)
Initial Amplifier
S -T Protocol
ELF EST
When the VL-1000 is initially turned on, it
enters a "S -T
ELF EST
amplifier's microprocessor checks various as-
pects of its control signals and supply voltages.
If the amplifier's self-test routine is success-
fully completed, the following display will be
shown:
Operation
" SWR (Dots on Graph)
UT
I " SWR (Dashes on
N
" mode, in which the
Page 11