Table of Contents
Advertisement
en Troubleshooting
Fault
Insufficient cleaning.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Odours have formed
in the appliance.
Damp stains have
formed on the fabrics
after the end of the
Iron Assist pro-
gramme.
Water is leaking from
below the door.
52
Cause and troubleshooting
Refill the dispenser.
4.
→ "Filling the dispensers", Page 33
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
Check whether the detergent used is suitable.
1.
→ "Detergents and care products", Page 29
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 37
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Filling the dispensers", Page 33
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 14
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 15
Humidity and detergent residue may promote the
formation of bacteria.
→ "Cleaning the drum", Page 36
▶
If you are not using the appliance, leave the door
▶
and detergent drawer open so that residual water
can evaporate.
Water droplets from the drum or from the door have
moistened the fabrics. The drops come from either
condensed steam or the residual moisture from the
previous wash programme.
Iron the fabrics or hang them up to dry.
▶
Dirt on the door or seal causes leaks.
Clean the door and the seal.
▶
Advertisement
Table of Contents
