Battery - Husqvarna EZ4624 Operator's Manual

Battery

Your mower is equipped with a maintenance free
battery and does not need servicing. However, periodic
charging of the battery with an automotive type battery
charger will extend its life.
Keep battery and terminals clean.
Keep battery bolts tight.
Recharge at 6-10 amperes for 1 hour
To clean battery and terminals
Corrosion and dirt on the battery and terminals can
cause the battery to "leak" power.
1. Open the terminal access doors.
2. Disconnect BLACK battery cable first, then the
RED battery cable and remove the battery from the
machine.
3. Rinse the battery with plain water and dry.
4. Clean terminals and battery cable ends with wire
brush until shiny.
5. Coat terminals with grease or petroleum jelly
6. Reinstall battery.
Replacing battery
1. Lift Seat and rotate forward.
2. Open terminal access doors.
3. Using two 1/2" wrenches disconnect BLACK
battery cable then RED battery cable.
4. Using 7/16" wrench, remove terminal guard.
5. Carefully remove the battery from the mower.
6. Install new battery with terminals in the same
position as the old battery.
7. Reinstall terminal guard.
8. First connect RED battery cable to positive (+)
battery terminal with hex bolt and hex nut.
9. Connect BLACK grounding cable to negative (-)
battery terminal with remaining hex bolt and hex
nut.
10. Tighten securely.
11. Close terminal access doors.
12. Lower seat.
MAINTENANCE
IMPORTANT INFORMATION
Do not attempt to open or remove caps or
covers. Adding or checking level of
electrolyte is not necessary.
Always use two wrenches for the terminal
screws
1. Terminal guard
2. Terminal access doors
Battery installation
Always use protective glasses
when handling the battery.
WARNING!
Do not short battery terminals by
allowing a wrench or any other
object to contact both terminals at
the same time. Before connecting
battery, remove metal bracelets,
wristwatch bands, rings, etc.
Positive terminal must be
connected first to prevent sparks
from accidental grounding.
CZ-22
39
-
English