Maintenance And Service; Cleaning Your Deck - Cub Cadet 19HP Enforcer 44, 21HP Enforcer 48, 23HP Enforcer 54 Operator's And Service Manual

Hydrostatic zero-turn commercial riding mower
Table of Contents

Advertisement

hair pin
Figure. 6
without offset, and with a maximum amount of sharp-
ened cutting edge.
Mulch- These blades are generally designed for use
in cutting decks equipped with mulch baffles. The
shape of the blade generally produces higher turbu-
lence in order that the grass can be repeatedly cut
and re-cut into smaller pieces. These blades gener-
ally require more horsepower than other blades.
Mulch blades work best when the grasses are cut at
the highest levels, minimal lengths of grasses are
removed, and grass conditions are generally dry.
MAINTENANCE AND
SERVICE
WARNING:
Disconnect the spark plug wires or remove the
key from the ignition to prevent the engine
from accidentally starting before performing
any maintenance on this mower.
A. Cleaning your Deck
Use the Deck Wash System to rinse grass clip-
pings fro the deck's underside and prevent the
buildup of corrosive chemicals. Complete the fol-
lowing steps after each mowing:
IMPORTANT: Make certain the machine's dis-
charge chute is directed away from people, chil-
dren, animals, and your house, garage, parked
cars, etc.
a. Drive the machine to a level, clear spot on
your lawn, near enough to a water faucet
(spigot) for your garden hose to reach.
b. Make sure that the PTO (mower deck
blade engage) control is in the "OFF" posi-
tion.
Trailing Link
hair pins
c. Move shift lever or speed control into the
"Neutral" position.
d. Set the parking brake, and turn the ignition
key to the "STOP" position to stop the
engine.
e. Thread hose coupler (packaged with this
manual) onto the end of your garden hose.
See Figure 7.
f.
Attach the hose coupler to the water port
on your mower deck's surface. See Figure
7. Turn the water on.
g. While sitting in the machine operator's
position, re-start the engine and place
throttle lever in the Fast (rabbit) position.
h. Move the PTO control to the "ON" position.
i.
Remain in the machine operator's position,
and with the mower deck engaged for a
minimum of two minutes per wash out,
start with the trim (operator's left) side, and
allow the underside of the cutting deck to
thoroughly rinse.
j.
Move the PTO control to the "OFF" posi-
tion.
k. Turn the engine off.
l.
Turn the water off, and detach the hose
coupler from the water port on your mower
deck.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents