Xerox DocuPrint 92C Installation Planning Manual page 48

CONTROLLER SPECIFICATIONS AND REQUIREMENTS
Sun Ultra 2 workstation placement
5-4
Caution: Position the table at least 6 inches / 15.2 cm from the wall.
Make sure the workstation processor and the HCU are at least 12
inches / 30.4 cm from the wall. Do not put the processor or the HCU
on the IPS printer.
Following are guidelines for placement of the Sun Ultra 2 workstation
components of the printer controller.
Figure 5-2. Sun Ultra 2 printer controller hardware
1 Mouse and mouse pad
2 Keyboard
3 Monitor
4 Processor
5 Table
When you place your workstation processor on a table top, make
sure to allow at least 6 inches / 152 mm of unobstructed space at the
rear and both sides of the processor. Do not allow any piece of
equipment to blow warm air into the air-intake vents of the processor.
Caution: Do not place a monitor with a base larger than the
processor on top of the unit. Do not block any fan or vents on the
sides or rear of the processor.
XEROX DOCUPRINT 92C IPS INSTALLATION PLANNING GUIDE