Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7736-K165
Summary of Contents for NCR 7736-K165
- Page 1 Kit Instructions M.2 Wireless Card and Antenna 7736-K165 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. -
Page 3: Kit Contents
M.2 Wireless Card and Antenna This kit provides an M.2 Wireless Card and Antenna for the NCR CX8 POS (7736). Kit Contents... -
Page 4: Installation Procedure
M.2 Wireless Card and Antenna Installation Procedure 1. Remove the Top Cover. • Top Cover without Duct a. Remove the four (4) screws securing the Top Cover to the chassis. • Top Cover with Duct a. Remove the four (4) screws securing the Top Cover to the chassis. - Page 5 M.2 Wireless Card and Antenna b. Slide the Top Cover in the direction shown. c. Lift the Top Cover away from the chassis. 2. Insert the Wireless Card into the connector.
- Page 6 M.2 Wireless Card and Antenna 3. Secure the Wireless Card with a screw. 4. Remove the knockout in the corner of the chassis.
- Page 7 M.2 Wireless Card and Antenna 5. Install the Antenna Coax Connector. a. On the inside of the chassis, insert the Antenna Coax Connector. b. On the outside of the chassis, secure the Antenna Coax Connector with a lock washer and nut. Note: Use a 5/16”...
- Page 8 M.2 Wireless Card and Antenna 7. Secure the Ground Cable under the corner Motherboard Screw. Note: Ensure the Ground Cable is off the Motherboard, away from components. 8. Connect the Antenna Cable to Connector 2 of the Wireless Card and route the Cable between the motherboard screw and the jumper as shown.