Dometic 50112 Installation Operation & Maintenance

DOMETIC CORPORATION
1120 North Main Street, Elkhart, IN 46514
Please Visit: WWW.DOMETIC.COM
ENGLISH
FOR YOUR SAFETY
READ ALL INSTRUCTIONS BEFORE OPERATING
Installer: Provide these instructions to the consumer.
Consumer: Keep documents for future reference.
SERVICE CALLS & QUESTIONS
Location and phone numbers of qualified Service Centers
can be found at our website http://www.edometic.com or
call 866-869-3118 to locate a Service Center.
MAY CAUSE PERSONAL INJURY OR DEATH
For your safety and protection, it is important that this
installation manual is read and understood before installation
or use. Failure to properly install the unit or attempting to
modify it in any way can be extremely hazardous and may
result in property damage and/or personal injury and will void
the warranty.
* If this unit is used to replace a previous model (Part # 53288), dimension 'C' must be modified to match the dimension shown in the
diagram.
WARNING
LITERATURE NUMBER MPD 50175
RECESSED GLASS
BI-FOLD COVER with TRIM
Model # 50112, 50200, 50278, 50279, 50291, 50292,
50850, 50851, 50852, 50853, 50854, 50855
●Installation ●Operation ●Maintenance
INSTALLATION
1. Follow CUTOUT DIMENSIONS and FIGURE 1 for the appropriate
Recessed Bi-Fold Cover with Trim installation.
Cutout must be squared to the counter top and cabinet face
2. Place the Bifold with Trim in the recessed cavity. The front section
should be flush with the front edge of the cabinet. The side trim
should be flush against the cutout and the gap from edge of glass
to the trim must be equal side-to-side.
3. Raise the cover. Install the screws into both sides of the trim
through the holes provided. See FIGURE 2. If needed add shims
behind the sides of the trim to square trim to counter top.
DO NOT OVERTIGHTEN SCREWS
Do not over tighten the installation screws. Overtightening
can cause damage to the product.
Follow MPD 52229 & 50467 for Dometic Range models
4.
complete installation, operation and maintenance instructions of
the range, cooktop or slide-in cooktop. Installation must conform
with local codes or in the absence of local codes, with the
American National Standard for Recreation Vehicles ANSI/A119.2
and Article 551, ANSI/NFPA 70. In Canada installation must
conform to CSA Z240.4.2-M.
*
OPERATION
Revision A, 08/28/18
CAUTION