Table of Contents
Advertisement
The programme starts.
11.2 Starting the programme
with delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again
and again until the display shows the
delay time you want to set.
You can delay the start
of a programme from a
minimum of 1 hour to a
maximum of 20 hours.
3. Press the Start/Pause touch button.
The display shows the countdown of
the delay start.
When the countdown is completed, the
programme starts.
11.3 Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
Alternatively:
1. Rotate the selector knob to the
"Reset" position.
2. Wait for 1 second. The display shows
.
3. Set the programme.
11.4 At the end of the
programme
When the programme is completed:
• An intermittent acoustic signal
operates.
• The display shows
• The indicator
• The indicators
may come on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the anti-crease phase for approximately
30 minutes or more if Extra Anticrease
option was set (see chapter
Extra Anticrease ).
The anti-crease phase reduces creasing.
is on.
Filter and
Tank
Option -
You can remove the laundry before the
anti-crease phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed.
When the anti-crease phase is
completed:
• The display still shows
• The indicator
• The indicators
remain on.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate
the appliance.
2. Open the appliance door.
3. Remove the laundry.
To keep the effects of
the Steam treatment,
clothes must be
removed one garment at
a time during the
anticrease phase and
hung immediately on a
clothes hanger to dry (for
minimum 5-15 min,
depending on fabric and
selected steam level).
Do up the buttons and
tug the garment into
shape, paying particular
attention to cuffs and
seams.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
settings. See chapter
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
Always clean the filter and
empty the water container
when a programme is
completed.
11.5 Stand-by function
To reduce energy consumption, this
function automatically deactivates the
appliance:
ENGLISH
23
is off.
Filter and
Tank
Adjustment of
Advertisement
Table of Contents
