Table of Contents
Advertisement
3.5
Pause programme - Pause mode
1.
To pause the programme, press the START/PAUSE button once during the workout.
During the pause mode, the workout data is shown with a "P" on the display (Fig. 6) and a beep sounds for
0.5 seconds every 30 seconds.
NOTICE
L
If the console does not receive any input within 5 minutes while in pause mode,
the console goes into standby mode.
2.
To resume, press the START/PAUSE key again.
3.6
End programme - stop mode
To end the programme, press the STOP button once.
+
While pressing, a signal sounds for 0.5 seconds and the console enters stop mode.
After 0.5 seconds, the display will first show the DISTANCE, TIME and CALORIES values of the
training session (Fig. 7).
+
After 7 seconds a short beep sounds and the maximum values of the training session for WATT,
SPEED and PULSE are shown on the display (fig. 8).
+
After 7 seconds a short beep sounds and the average values of the training session for WATT,
SPEED and PACE are shown on the display (fig. 9).
NOTICE
L
The values are displayed three times in total, after which the console goes into standby mode.
Fig. 7
Fig. 8
Fig. 9
Fig. 6
19
Advertisement
Table of Contents
