Rear Panel (Connecting Your Equipment) - Boss Vocal Performer VE-22 Reference Manual

Rear panel (connecting your equipment)

* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
TIP: HOT
RING: COLD
SLEEVE: GND
1
INPUT connector
Connect your microphone here.
2
[MIC SENS] knob
Adjusts the input sensitivity for the mic. Set this by following the
steps in "Configuring the mic settings (MIC)" (p. 5).
3
[PHANTOM] switch
Set this to match the mic you've connected.
When using a condenser mic, set this to "ON", and when using a
dynamic mic, set this to "OFF".
About phantom power
This unit can supply phantom power (+48 V) to the mic. When
using a condenser mic that requires phantom power, set the
[PHANTOM] switch to "ON" ("Phantom power settings" (p. 4)).
4
OUTPUT R, L/MONO connectors
Connect this to your PA mixer or other audio equipment.
This is for audio output.
Use the "OUTPUT" (p. 21) setting to set the type of audio for
output.
5
PHONES/LINE OUT jack
Connect a pair of headphones (sold separately) that uses a stereo
mini plug cable here.
For line-level output to a mixer, connect a commercially available
stereo miniature phone to RCA phono type cable to the PHONES/
LINE OUT jack.
6
AUX IN jack
When you connect an audio player or other device that uses a
stereo mini plug to this jack, the sound from that device is mixed
and sent to the OUTPUT connectors and the PHONES/LINE OUT
jack.
This lets you practice singing along with backing tracks.
* Use the controls of the connected device (such as an audio player)
to adjust the volume.
1 2 3
* Pin assignment of INPUT, OUTPUT connector
INPUT connector OUTPUT connector
※ INPUT端子 ※ OUTPUT端子
2: HOT 1: GND 1: GND
3: COLD
5 6
4
2: HOT
3: COLD
7
CTL 1, 2/EXP jack
You can control various parameters from a connected device with
a footswitch (FS-5U, FS-6, FS-7: sold separately) or an expression
pedal (EV-30, FV-500L, FV-500H or Roland EV-5: sold separately)
that's connected to the CTL 1,2/EXP jack (p. 15).
* Use only the specified expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage
to the unit.
8
USB port
Use this port to connect the VE-22 to your computer or iOS device
for recording ("USB" (p. 25)).
Use a USB Type-C® cable.
* Do not use a USB cable that is designed only for charging a device.
Charge-only cables cannot transmit data.
9
DC IN jack
Connect an AC adaptor (BOSS PSA-S series, sold separately) here.
* Use the cord hook to secure the cord of the AC adaptor as shown
in the illustration.
10
[POWER] switch
Turns the power on/off.
11
Ground terminal
Connect this to an external earth or ground if necessary.
10
8
11
7
9
AC adaptor cord
Cord hook
Getting ready
3