Preparation Before Use - Eureka NEY100 Series Owner's Manual

Hide thumbs Also See for NEY100 Series:

Never operate vacuum cleaner without water tanks, brush, ﬂoat and

brush cover, water tanks cover in proper position.

Pull up

1. One hand on the machine, the other hand

pulls clean water tank handle upward

vertically, and the tank will be taken out.

Press

4. Put the head of the clean water tank into

the open support position of the machine,

and then press vertically down. After hearing

the click, the installation is successful.

Attention:

The disassembly / installation method of dirty

water tank is the same as that of the clean

water tank.

Please DO NOT add water to the dirty water

tank.

Preparation before Use

3. If desired add cleaning solution for deep cleaning.

Cleaning solution dosage recommended as below：

•Large Area Water + 5 Capfuls Solution

•Small Area Water + 2 Capfuls Solution

The amount of cleaning solution should be used according to

the cleaning area

CAUTION

2. Open the upper cover of clean water

tank, and pour tap water into the tank,

then put on the upper cover.

5. Insert the hose into the carpet brush.

After hearing the click, the hose is

successfully connected to the carpet

brush. Press the lock cap, pull out in the

direction shown in the picture, and then

remove the carpet brush.

Open

Clean water tank

switch lock

www.eureka.com

Table of Contents