Hunter Swanson Installation Manual page 9

1
bag
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
To install the shade, first loosen
the thumb screws. Raise the
shade to the light fixture. Tighten
all thumbscrews securely.
Repeat x3
Note:
Fan style may vary.
Ceiling Bracket Downrod
Assembling the Light
2
2 of 3
Upper Switch
Housing Screw
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
5
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
Installing the Bulbs and Glass
Hanging Fan Wiring
3
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
6
Screw
Holes
Install the three switch housing screws found in the
hardware bag
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x3
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Canopy Blades
1 of 3
Upper Switch
bag
Housing Screw
3 of 3
Light Kit Screw
bag
ON
Light Bulbs/Glass
1886
8