Hunter Swanson Installation Manual page 5

You have two options for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan's box.
Do this first!
OFF
Box Outlet Mount
Option 1:
Machine Screws
Use machine screws
(provided with outlet box)
and washers when securing
to existing ceiling fan-rated
outlet box. Make sure it is
securely installed and is
acceptable for fan support of
31.8 kg (70 lbs) or less.
For angled ceilings,
point opening
toward peak.
Single Switch Wiring
Green, Green Yellow Stripe, or Bare (grounding)
Ceiling Bracket Downrod
Installing the Ceiling Bracket
Option 2:
Wood Screws
Use wood screws and
washers (included)
1
when securing to
support structure with
approved electrical
outlet box. Drill 9/64"
pilot holes in support
2
structure to aid in
securing ceiling
bracket with hardware
found in the
hardware bag.
White (grounded) N
Black (ungrounded) L1
Hanging Fan Wiring
Building Structure Mount
Wiring the Fan
Connect wiring from ceiling to terminal block (on
side of canopy mount) and tighten using flathead
screwdriver (included).
Canopy
Hunter Pro Tip:
The machine screws are the ones
that came with your outlet box.
1
2
WARNING
•To avoid possible electrical shock, before installing
your fan, disconnect the power by turning off the circuit
breakers to the outlet box associated with the wall switch
location.
•All wiring must be in accordance with national and local
electrical codes ANSI/NFPA 70. If you are unfamiliar with
wiring or in doubt, consult a qualified electrician.
•The ceiling fan must be grounded. If the ground wire for
the installation site is not present, immediately STOP
installation and consult a qualified electrician.
Blades Light
1886
x2
Washer
bag
x2
Wood Screw
4
Bulbs/Glass