Advertisement
3
Ready
Charge
5
-
2
Electrode Rod Setup Instructions
Ａ．Stylus Shaft
B. Brass Collet
Assemble/Exchange the electrode rod in the following steps:
1. Detach the stylus cap directly from the stylus handpiece.
2. Unscrew the collet cap counterclockwise until the first electrode rod can be installed or the old electrode rod can be
removed.
3. Insert the new electrode rod into the brass collet and adjust the rod to the appropriate length.
4. Tighten the brass collet by turning collet cap clockwise until the electrode rod fits securely.
5. Reattach the stylus cap onto the stylus handpiece.
1. Ensure that the electrode rods extend beyond the stylus cap by 1/8 to 1/4 inch (3.175 to 6.35mm).
2. After several uses, oxidation may develop on the electrode rods. If welding performance diminishes, it is
advisable to delicately sand the rods using 1000-grit sponge sandpaper.
JOULES
+
ON/OFF
3
2
4
A
C. Collet Cap
Welding Operating Instructions
1. Turn on the power switch.
2. Use the +/- button to set the desired power level (30
settings ranging from 1 - 30 joules).
3. Press the ON/OFF button; the green "ready"
indicator signifies the machine is in welding mode.
4. Weld by bringing the tip of the Stylus handpiece in
contact with the workpiece. Secure the handpiece in
the holder if needed, utilizing optional accessories.
5. After welding, the "Charge" indicator turns red,
signifying a brief recharging period. Wait for the
"Ready" indicator to turn green before proceeding to
the next welding operation.
B
C
D. Electrode Rod
H
Permanent Jewelry Welder User Guide 04
You can adjust the power level whenever
the 'Ready' indicator is green.
D
E
E. Stylus Cap
Advertisement
