Advertisement
With a DSS Receiver
IN FROM
1) Record and view any channel including
scrambled channels; channel selection
must be made at the DSS Receiver.
Su
2) Program one channel for unattended
recording.
NOTE: The DSS receiver must be turned
off to view programs from a cable
box or antenna. See the DSS
manuali for details.
**DSSÓ is a registered trademark of DIRECTV, INC., a unit of GM Hughed Electronics.
Audio/Video Connections
If your TV has AUDIO IN and VIDEO IN terminals, you can connect
your VCR to them to receive a higher quality picture and sound.
Audio/Video Connections
>
IN FROM ANT
A
Wy
OUT TO TV
aril
CH
AUDIO
IN
AUDIO OUT | esll
Se
TU
SA
O
a
A N Y
Q^ q Q
\
N
Sa,
VIDEO IN PY Xo,
1 Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV.
2 Connect the AUDIO OUT terminal on the VCR to the AUDIO IN terminal of your TV.
3 Set the VIDEO/TV selector of your TV (Monitor/Receiver) to "VIDEO."
NOTE: To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to "VIDEO."
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC in USA (and to the
Canadian Electrical Code in Canada) that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
Advertisement
