Installing The Grounding Lug On A Cisco 3660 Router - Cisco 2600 Series Installing

The following warning applies to routers that use a DC power supply:
After wiring the DC power supply, remove the tape from the circuit breaker switch
Warning
handle and reinstate power by moving the handle of the circuit breaker to the ON
position.

Installing the Grounding Lug on a Cisco 3660 Router

To attach the grounding lug to your router chassis, complete the following tasks:
Turn OFF power to the router. However, to channel ESD voltages to ground, do not unplug the power
Step 1
cable. Remove all network interface cables, including telephone cables, from the rear panel.
The following warning applies to routers that use a DC power supply:
Before performing any of the following procedures, ensure that power is removed from
Warning
the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel
board that services the DC circuit, switch the circuit breaker to the OFF position, and
tape the switch handle of the circuit breaker in the OFF position.
Strip one end of the 6-AWG wire to expose approximately 0.75 in. (20 mm).
Step 2
Crimp the grounding lug around the wire. (See Figure 16.)
Step 3
Figure 16
Step 4 Use the no. 2 Phillips screwdriver to fasten the grounding lug to the Cisco 3660 router chassis. (See
Figure 17.)
78-11640-01
Crimping the Lug Around the Wire
Installing the Grounding Lug on Cisco 2600 Series and Cisco 3600 Series Routers
Installing the Grounding Lug on a Cisco 3660 Router
11