Installation; Install The Unit; Remove The Unit - XOVision X348NT User Manual

Installation

Before installing the receiver permanently, fit it in the approximate place in your car ,and connect the
equipment according to the speakers and electrical connections. When
your system is operated properly,(preferably with the
car engine running), follow the instructions
for permanent installation
of your system.

INSTALL THE UNIT

1)Install half sleeve, can be with or
without adapter. It will fit better
with adapter.
2)Bend over some tabs to secure
the half sleeve inside of dash.
3) Support strap to be strutted
under dash, secure this strip to
avoid skipping of disc.

REMOVE THE UNIT

Insert removal wrench into the small
gap on the right side of the unit and pull
the unit slightly out on the same side,
then release the wrench. Repeat the
same action for the left side. By now,
you can remove the unit and unplug
the wires connector.
2)Bend over tabs
of half sleeve
(supplied)
3) Two wrenches for releasing
the unit (supplied)
5
1) Adapter
(not supplied)
Half sleeve
(supplied)