Indoor wireless/wired ip network camera (58 pages)
Summary of Contents for X10 VK49A
Page 1
Indoor/Outdoor Color Camera with Built-in 2.4 GHz Wireless Video Sender, plus X10 controlled power supply, and separate Video Receiver. OWNER'S MANUAL VR31A XC10A XM10A VK49A ODEL XC10A C , XM10A INCLUDES AMERA ADDRESSABLE VR31A V POWER SUPPLY IDEO ECEIVER...
Also included is a remote controlled power supply, Model XM10A, which lets you turn the camera on and off by remote control from any X10 remote control (sold separately). You can purchase additional cameras and power supplies so you can have a multiple camera system.
11. Power Sources - This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type or power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions.
UPPLY Power Supply Socket Used to set the code that the XM10A responds to, so you can turn the camera connected to it on and off by remote control (using X10 remote controls, sold separately). ONTROLS AND ONNECTIONS IDEO IDEO...
Page 5
ONTROLS AND ONNECTIONS AMERA IDEO ENDER 2.4 GHz Video Antenna Mounting plate Set channel switch to match setting on Video Receiver. Cable adapter. IDEO ECEIVER 2.4 GHz Video Antenna TV Output Connector TO TV DC 12V VIDEO OUT AUDIO OUT TV Channel 2.4 GHz Channel A/V Jacks...
Page 6
7. Set the Housecode dial to a letter between A and P that matches the Housecode dial on the X10 remote controls you want to use it with. Set the Unit Code dial to a number between 1 and 16. This lets you turn the camera connected to the XM10A on and off by remote control (using X10 remote controls, sold separately).
Page 7
OOKING UP THE IDEO ECEIVER 1. Connect a set of Audio/Video TO TV cables to the A/V OUT jacks on the Video Receiver. Connect the other end to your TV (use either L or R channel for audio). 2. Plug the Video Receiver's Power Supply jack (the power supply with VIDEO AUDIO...
Video Receiver (3 or 4). Check that the camera's remote controlled power supply is turned on (using any X10 remote control, sold separately). Note, when you first plug the power supply in, it will normally be ON.
Page 9
X10 (USA) Inc. 3824 North 5th St., Suite C, North Las Vegas, NV 89030 Web Site: www.x10.com VK49A-03/99...