Advertisement
SPECIFICATIONS FOR THE BBE 702
Frequency Response
Bypass .DC to 20kHz
Process Mode
.program controlled
Noise in Process Mode.-85dBu below OdBu output level
Total Harmonic Distortion
in process mode.less than 0.1% @ 1kHz @ +4dBu
Input Characteristics.Pin 3 hot
Input Impedance
.15k Ohms (balanced or unbalanced)
Nominallnput Range .-lOdBu to+8dBu
Maximum Input Level.+23dBu (input clip point)
Output Characteristics .Pin 3 hot
Minimum Load Impedance
for Full Output.600 Ohms (balanced or unbalanced)
Nominal Output Level.-lOdBu to +8dBu
Maximum Output Level .+23dBu into 600 Ohm load (clip point)
Output Impedance.600 Ohms (balanced or unbalanced)
Power Requirements .250mA @ +/-15VDC regulated
65mA @ +/-24VDC unregulated; 8w
Dimensions
.5.25"H x 1.5'*W x 9.5"D
(depth is measured from the rear of the front panel)
Weight
.lOoz.
Note: 0dBu=0.775Vrms
ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Advertisement
