Table of Contents
Advertisement
4 - ASSEMBLY
In order to protect the optical head during shipment, it has been
packed apart from the base.
1.
Remove head/mast assembly and base assembly from carton.
2.
Place free square end of mast into square hole in top of base
assembly. Be sure holes in side of mast line up with holes in side
of base.
3.
Using hardware supplied, assemble as below:
NOTE: Press mast tightly into corner prior to tightening mast mount¬
ing screws.
\
NOTE: Lockwashers and nuts not necessaiy on rear panel.
4
Advertisement
Table of Contents
