Table of Contents
Advertisement
T R O U B L E S H O OT I N G
Problems:
• L oud noise from blender
container blade area
• Container blades do not spin
• Increased vibration
• Leaking from bottom of container
• L oud grinding noise from the
blender motor
• Machine will not run
• Display window does
not say "Ready"
• Machine starts then shuts off
• Display window reads
"SHUT DOWN SEE MANUAL"
• D isplay window reads
"MOTOR LOCKED PROGRAM
TERMINATED"
• Machine is running irregularly
• "NO PROGRAM" is displayed
when a button is pushed
• Button pressed starts wrong
program
• Machine starts by itself
• A specific program
button is defective
• M achine does not work
when first tried
• M achine works but no information
displayed on screen
• P rogram buttons run the blender
on the same speed
22
Possible Actions:
a. B roken or worn drive socket. Replace (Item
#891). Instructions are included with part.
b. C heck blade assembly for loose, damaged
or nicked components and replace.
c. Tighten retainer nut with the retainer nut
wrench moving clockwise until it is snug.
(See page 17.)
Damaged motor bearings, your machine
may need to be repaired.
a. D ouble-check to make sure power
cord is firmly in power outlet.
b. Check to make sure the On/Off power
switch is in the on position.
c. Turn the On/Off power switch to off,
then on, to reboot the electronics.
Make sure there is power to the machine.
Let the machine cool for an hour, restart.
Let the machine cool for an hour, restart.
a. T urn the machine off and on again
to reset the programming.
b. Try plugging the machine into a
new outlet.
Advertisement
Table of Contents
