Troubleshooting; Removing The Built-In Rechargeable; Battery - Panasonic ER-GP21-K820 Operating Instructions Manual

Troubleshooting

Problem
The clipper has become
blunt.
Operating time is short.
Clipper stopped
functioning.
The clipper cannot be
charged.
Makes a loud sound.
If the problems still cannot be solved, contact the store where you
purchased the appliance or a service centre authorised by
Panasonic for repair.
ER-GP21_CIS.indb 11
Action
Until problems are solved, please
follow each procedure as follows;
1. Charge the clipper.
(See page 8.)
2. Clean the blade and apply oil.
(See pages 9 and 10.)
3. Replace the blade.
(See page 9.)
4. Have the battery replaced by an
authorized service centre.
Push the main body into the charging
stand or appliance plug all the way.
Charge within the recommended
charging temperature of 0 °C to
35 °C.
Apply oil.
(See page 10.)
Have the battery replaced by an
authorized service centre.
Removing the built-in rechargeable battery
Remove the built-in rechargeable battery before disposing the
clipper.
Please make sure that the battery is disposed of at an officially
designated location if there is one.
This figure must only be used when disposing the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it may cause malfunction.
• Remove the clipper from the AC adaptor.
• Slide the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps 1 to 8 and lift the battery, and then remove it.
• Take care not to short circuit the positive and negative terminals
of the removed battery, and insulate the terminals by applying
tape to them.
 




For environmental protection and recycling of materials
This clipper contains a Nickel‑Metal Hydride battery.
Please make sure that the battery is disposed of at an officially
assigned location, if there is one in your country.


11
2015/12/02 18:01:26