Table of Contents
Advertisement
en Before using for the first time
To align the appliance, turn the ap-
2.
pliance feet. Check that the appli-
ance is level using a spirit level.
All appliance feet must stand firmly
on the ground.
Use a WAF 17 wrench to tighten
3.
the lock nuts against the housing
until they are hand-tight.
In doing so, hold the foot tight and
do not adjust its height.
16
Before using for the first time
5 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
5.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Turn the programme selector to
1.
Drum Clean
Close the door.
2.
Pull out the detergent drawer.
3.
Pour approx. 1 litre of tap water
4.
into compartment II.
.
Advertisement
Table of Contents
