Dell NOT22366 Owner's Manual page 123

Table 34. System setup options — Storage menu (continued)
Storage
Drive Information
SATA-0
Type
Device
M.2 PCIe SSD
Type
Device
Table 35. System setup options — Display menu
Display
Display Brightness
Brightness on battery power
Brightness on AC power
Table 36. System setup options — Security menu
Security
TPM 2.0 Security
Clear
PPI Bypass for Clear Commands
Data Wipe on Next Boot
Start Data Wipe
122 BIOS setup
By default, the SATA-0 option is enabled.
By default, the M.2 PCIe SSD option is enabled.
Displays the SATA-0 type information of the computer.
Displays the SATA-0 device information of the computer.
Displays the M.2 PCIe SSD type information of the computer.
Displays the M.2 PCIe SSD device information of the computer.
Allows the user to set the screen brightness level when the computer is
running on battery power.
By default, the Brightness on battery power level is set to 70.
Allows the user to set the screen brightness level when the computer is
running on AC power.
By default, the Brightness on AC power level is set to 100.
When enabled, the Clear option clears information stored in the TPM after
exiting the system's BIOS. This option returns to disabled state when the
system restarts.
By default, the option is disabled.
Enables or disables the TPM Physical Presence Interface (PPI).
When enabled, this setting allows the operating system to skip BIOS PPI user
prompts when issuing the Clear command. Changes to this setting take effect
immediately.
By default, the option is disabled.
Enables or disables the Data Wipe feature.
When enabled, the BIOS will queue up a data wipe cycle for storage device(s),
connected to the computer, on next reboot.
WARNING: Secure Data Wipe operation deletes information in a way
that it cannot be reconstructed.
By default, the option is disabled.