Table of Contents
Advertisement
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions.
No further lubricant is necessary.
BRUSH INSPECTION
At approximately 100 hours of use, take or send your tool to your
nearest Authorized Porter-Cable Service Station to be thoroughly
cleaned and inspected; worn parts replaced, when necessary;
relubricated with fresh lubricant, if required; reassembled with new
brushes; and performance tested.
Any loss of power before the above maintenance check may indicate
the need for immediate servicing of your tool. DO NOT CONTINUE
TO OPERATE TOOL UNDER THIS CONDITION. If proper operating
voltage is present, return your tool to the Service Station for immediate
service.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of
parts due to wear from normal use. These operations, including brush
inspection and replacement, should ONLY be performed by either
an AUTHORIZED PORTER-CABLE SERVICE STATION or a
PORTER-CABLE SERVICE CENTER. All repairs made by these
agencies are fully guaranteed against defective material and
workmanship. We can not guarantee repairs made or attempted by
anyone other than these agencies.
Should you have any questions about your tool, feel free to write us
at any time. In any communications, please give all information shown
on the nameplate of your tool (model number, type, serial number,
etc.).
ACCESSORIES
The testing of this tool has been accomplished with the following
accessories. For safest operation, it is recommended that only these
accessories be used with this product.
WARNING - Since accessories other than those listed have not been
tested with this product, use of such accessories could be hazardous.
ACCESSORIES FOR MODELS 518 AND 520
42596
Wrench
10695
Sub-Base (Standard)
42187
Clear Sub-Base
(2Vz"
Hole)
43000
1 /4" Collet
43001
3/8" Collet
42591
1
12"
Collet
696
Shaper Table
12
Advertisement
Table of Contents
