Smeg U8C082DE User Manual page 15

Hide thumbs Also See for U8C082DE:
Table of Contents

Advertisement

Problem
The appliance is noisy.
Acoustic or visual alarm is on.
The compressor operates contin‐
ually.
The compressor does not start
immediately after pressing the
"Super", or after changing the
temperature.
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and ice.
Possible cause
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The door is left open.
Temperature is set incorrectly.
Many food products were put in
at the same time.
The room temperature is too
high.
Food products placed in the ap‐
pliance were too warm.
The door is not closed correctly.
The Super function is switched
on.
The compressor starts after a pe‐
riod of time.
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correctly.
The gasket is deformed or dirty.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Solution
Connect a different electrical ap‐
pliance to the mains socket. Con‐
tact a qualified electrician.
Check if the appliance stands
stable.
Close the door.
Refer to "Control panel" chapter.
Wait a few hours and then check
the temperature again.
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door" sec‐
tion.
Refer to "Super function" section.
This is normal, no error has oc‐
curred.
Refer to installation instructions.
Wait a few seconds between
closing and re-opening of the
door.
Close and open the door.
Contact the nearest Authorized
Service Centre.
Refer to "Closing the door" sec‐
tion.
Refer to "Closing the door" sec‐
tion.
Wrap the food products better.
Refer to "Control panel" chapter.
ENGLISH
33

Advertisement

Table of Contents
loading

Table of Contents