Table of Contents
Advertisement
Problem
Temperature cannot be set.
The temperature in the appliance
is too low/too high.
Temperature setting LEDs flash
at the same time.
If the advice does not lead to the
desired result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
Possible cause
The FastFreeze function is
switched on.
The temperature is not set cor‐
rectly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often.
The FastFreeze function is
switched on.
There is no cold air circulation in
the appliance.
An error has occurred in measur‐
ing the temperature.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Switch off FastFreeze function
manually, or wait until the func‐
tion deactivates automatically to
set the temperature. Refer to
"FastFreeze function" section.
Set a higher/lower temperature.
Refer to "Closing the door" sec‐
tion.
Let the food products tempera‐
ture decrease to room tempera‐
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Refer to "FastFreeze function"
section.
Make sure that there is cold air
circulation in the appliance. Refer
to "Hints and tips" chapter.
Contact the nearest Authorised
Service Centre. The cooling sys‐
tem will continue to keep food
products cold, but temperature
adjustment will not be possible.
ENGLISH
35
Advertisement
Table of Contents
