Table of Contents
Advertisement
Problem
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and ice.
Water flows on the rear plate of
the refrigerator.
There is too much condensed
water on the rear wall of the re‐
frigerator.
Water flows inside the refrigera‐
tor.
Water flows on the floor.
34
ENGLISH
Possible cause
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correctly.
The gasket is deformed or dirty.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appliance
is too low and the ambient tem‐
perature is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
Food products prevent the water
from flowing into the water collec‐
tor.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
Solution
Refer to installation instructions.
Wait a few seconds between
closing and re-opening of the
door.
Close and open the door.
Contact the nearest Authorized
Service Centre.
Refer to "Closing the door" sec‐
tion.
Refer to "Closing the door" sec‐
tion.
Wrap the food products better.
Refer to "Control panel" chapter.
Set a higher temperature. Refer
to "Control panel" chapter.
Set a higher temperature. Refer
to "Control panel" chapter.
This is correct.
Open the door only when neces‐
sary.
Make sure the door is closed
completely.
Wrap food in suitable packaging
before storing it in the appliance.
Make sure that food products do
not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Advertisement
Table of Contents
