Daily Use - Smeg LVS342CQSX User Manual

Table of Contents

Advertisement

3. Remove the spilled rinse aid with an
absorbent cloth to prevent excessive
foam formation.
4. Close the lid. Make sure that the release
button locks into position.

10. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance.
Make sure that the appliance is in programme
selection mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start a programme suitable for
the type of load and the degree of soil.
10.1 Using the detergent
A
B
30
20
CAUTION!
Only use detergent specifically designed
for dishwashers.
1. Press the release button (B) to open the
lid (C).
2. Put the detergent, in powder or tablets, in
the compartment (A).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the release
button locks into position.
C
You can turn the selector of the
released quantity (B) between position 1
(lowest quantity) and position 4 or 6
(highest quantity).
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
Do not fill the compartment (A) with
more than 30 ml of gel detergent.
10.2 Setting and starting a
programme
The Auto Off function
This function decreases energy consumption
by deactivating automatically the appliance
when it is not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not
started.
Starting a programme
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in programme selection mode and the
door is closed.
2. Press Program again and again until the
indicator of the desired programme is on.
The display shows the programme duration.
3. Set the applicable options.
4. Press Start to start the programme.
• The indicator of the running phase is
on.
• The programme duration starts to
decrease with steps of 1 minute.
ENGLISH
15

Advertisement

Table of Contents
loading

Table of Contents