ADJUST
FIG. B-2 CENTER CONVERGENCE ADJUSTMENT
BLUE
BLUE
RED
4-POLE MAGINETS MOVEMENT
FIG. B-3 CENTER CONVERGENCE ADJUSTMENT
5-3-8. White Balance Adjustment
NOTE
The purpose of this procedure is to optimize the picture tube to obtain
good black and white picture at all brightness levels while at the same
time achieving maximum usable brightness. Purity and convergence
adjustment must be processed in advance. Press the OUTCONDITION
key on the remote control unit.
1. On Factory Mode, select number 3.
2. Press FACTORY key again to return to Factory Mode screen and select 1. White Balance.
3. In case of Screen adjustment, the color of horizontal bar can be used as a standard one and
use other two colors to adjust W/B.(AC 100 equipment used)
RED
BLUE/RED
GREEN
19
Vertical Green Belt
BLUE
RED
6-POLE MAGINETS MOVEMENT