Power Supply - Philips AZ2755 Manual

Whenever convenient, use the power supply if you want to
conserve battery life. Make sure you remove the plug from the
set and wall socket before inserting batteries.
BATTERIES (OPTIONAL)
1. Open the battery compartment and insert six batteries, type
R-20, UM-1 or D-cells, (preferably alkaline) with the correct
polarity as indicated by the "
compartment.
Remote control (supplied)
Open the battery compartment and insert two batteries,
type AAA, R03 or UM4 (preferably alkaline).
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
3. Remove the batteries if the set is not to be used for a long
time.
Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
• Do not mix battery types: e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
• When inserting new batteries, do not try to mix old batteries
with the new ones.
• Remove the batteries if the set is not to be used for a long
time.
Using AC MAINS
1. Check if the MAINS voltage as shown on the type plate
on the base of the set, corresponds to your local mains
supply. If it does not, consult your dealer or service centre.
– If your set is equipped with a voltage selector, adjust the
selector to correspond with your local mains voltage.
2. Connect the mains lead to the MAINS socket and the wall
socket. The mains supply is now connected and ready for
use.
3. To switch off completely, withdraw the mains lead from the
wall socket.
– Disconnect the mains lead from the wall socket to protect
your set during heavy thunderstorms.
Batteries contain chemical substances, so they should
be disposed of properly.
The type plate is located on the bottom of the set.
Switching POWER on/off: Save energy
Whether you are using mains or battery supply, to avoid
unnecessary energy consumption always push the POWER
button to the off position after using the set.
+ -
" and " " symbols inside the

POWER SUPPLY

6 x R20•D-CELL•UM-1
AC
MAIN
5