Power Supply; Basic Functions; Adjusting Volume And Sound - Philips AZ3068 User Manual

POWER SUPPLY

POWER SUPPLY
Whenever convenient, use the mains supply to
conserve battery life. Make sure you remove the
power plug from the set and wall socket before insert-
ing batteries.
Batteries (not included)
• Insert 6 batteries, type R-20, UM-1 or D-cells,
(preferably alkaline) with the correct polarity.
(See A)
Remote control
Important!
• Before using the remote control, remove the
insulation plastic tab as shown in fig. A.
• If the remote control does not function cor-
rectly or the operating range is reduced,
replace the battery with a new (CR2025) type
battery
1 Pull the battery tray out.
2 Replace a new battery
3 Fully insert the battery tray back to the original
position.
Incorrect use of batteries can cause electrolyte leak-
age and will corrode the compartment or cause the
batteries to burst.
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
• When inserting new batteries, do not try to mix old
batteries with the new ones.
• Batteries contain chemical substances, so
they should be disposed of properly.
Using AC Mains
1 Check if the mains supply, as shown on the type
plate located on the bottom of the set, corre-
sponds to your local mains supply. If it does not,
consult your dealer or service centre.
2 Connect the mains lead to the wall socket.
3 To disconnect the mains supply, unplug the set from
the wall socket.
4 Install the unit near the AC outlet and where the
AC power plug can be easily reached.
All markings are located on the bottom of
the set.

BASIC FUNCTIONS

Auto-Standby mode
When a CD has reached the end of playback and
remains in the stop position for more than 15 minutes,
the set will switch off automatically to save mains.
When in pause position for 5 minutes, the CD playback
will stop automatically. 15 minutes later, the set
switches off.
BASIC FUNCTIONS
Switching on and off and selecting function
1 Press STANDBY y (on the set only) to switch on.
2 Press Source selector once or more to select: CD,
TUNER, AUX or TAPE function.
3 Press y to switch off the set.
Helpful hints:
– To change from TAPE to CD, TUNER or AUX
function, or when you are switching off the set:
first, make sure you press the tape STOP 9 key to
end playback and all the cassette keys are
released.
– The tone, sound settings, tuner presets and the
volume level (up to a maximum volume level of 20)
will be retained in the set's memory.

ADJUSTING VOLUME AND SOUND

• Adjust the volume with the VOLUME control.
= Display shows the volume level
number from 0-32. (See 2)
Bass adjustment
There are three DBB (Dynamic Bass Boost) options:
– Off: no bass enhancement
– DBB1: moderate bass enhancement
– DBB2: strong bass enhancement
• Press DBB once or more to select your option.
™DBB1,2 appears if DBB is activated.
How to MUTE the sound
1. Press MUTE on the remote control to interrupt
sound reproduction instantly.
= Playback continues without sound and in the
display flashes .
2. To reactivate sound reproduction you can:
– press MUTE again;
– adjust the volume controls;
– change to another source.
and a