Prior To First Use; Daytime Setting; First Cleaning - Electrolux EOB 946 Instruction And Installation Manual

Prior to first use
In the chapters "Daytime setting" and "First heating-up" the
manipulation steps for the electronic oven control are just
briefly described with hints on buttons and symbols: Relevant
explanatory information you will find in the following chapter
"The electronic oven control":
Daytime setting
The appliance must be switched off when setting or re-
setting the daytime.
After connection to the power supply or after a power
failure 12 00 will flash for about 5 seconds in the display.
Afterwards 12 00 will remain on and between the indi-
cator for hours and minutes will flash. The actual day-
time between 0.00 - 23.59 hours has to be set.
As long as 12 00 is flashing:
by means of the rigth rotary knob (vy ~~ 4)
set the daytime.
With 12.00 already remaining on in the display and with
« flashing:
At first do simultaneously push the buttons
|! (program duration) and —' (end of
cooking time) for about 5 seconds since 12 00
flashes,
by means of rotary knob » 4 then set the
daytime.
After 5 seconds the time will remain in the display and
« is flashing between the indication of hours and minu-
tes. The setting procedure is completed.
In case of corrections of time (Summer/#inter time,
power failure, etc.) proceed in same manner.
First cleaning
To remove any possible production remnants, the ap-
pliance should be cleaned before use.
Remove any possibly existing labels and protective fo-
ils from control panel and oven door.
Remove the accessories from the oven and rinse them.
Clean the oven and the door with warm water and a
cleanser and dry afterwards.
With that the oven light may be switched on:
e Push button © (on/off) for switching on
the oven light and for switching off.