Table of Contents
Advertisement
SPECIFICATIONS
Cat. No. ......................................
Volts ...........................................................
Battery Type ................................................
Charger Type ...............................................
Rated RPM ........................................
Spindle Thread Size .........................................
Max Capacity ............
Weight ........................................
Recommended Ambient
Operating Temperature .................. -17°C to 51°C
Recommended Lanyard...................
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For
specific
charging
operator's manual supplied with your charger
and battery.
Inserting/Removing the Battery
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended
Others may be hazardous.
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove the battery pack
WARNING
any time the tool is not in use.
To reduce the risk of injury when
WARNING
grinding, always use properly
installed guards. The guard type must match
the wheel type to provide maximum protection
for the operator if the wheel should break.
To reduce the risk of injury,
WARNING
always use the side handle when
using this tool. Always use with both hands
while operating the tool. Hold securely.
Adjusting the Type 27 Guard
Remove battery to avoid starting the
WARNING
tool.
To adjust the guard, press in the guard lock lever
and rotate the guard to one of five detent slots.
Always adjust the guard to provide
WARNING
the
protection while operating. Do not modify the
Type 27 guard.
NOTE: Type 27 Guard is not removable.
M18 FSAGES125
3,500 - 8,500
125 mm x 6.35 mm (5"x 1/4")
2.3 kg (Tool-Only)
MILWAUKEE
Energy Absorbing
instructions,
read
for
this
operator
with
maximum
Operator's Zones
Installing/Removing the Type 1 Clip-on
18 V DC
WARNING
M18™
M18™
WARNING
M14
protection while operating. Do not modify the Type
27 guard.
1.
To install the Type 1 clip-on guard, slide the Type
1 clip-on guard over the Type 27 guard until it
clips into place.
®
the
2. To remove, separate the Type 1 clip-on guard
from the Type 27 guard.
The side handle position may be used on either
tool.
side or the centre of the tool.
WARNING
• Slide and hold the arm pivot lock down and
position the side handle in the location which offers
best control and guard protection. Once the side
handle is adjusted, release the arm slide switch
and ensure the side handle arm is locked into
position.
• To adjust the angle of the side handle, slide the
spring-loaded inner flange of the handle away from
the tool. While holding the flange locate the handle
in one of the 3 options best suited to the specific
operation intended. Slowly release the flange to
lock the handle at the desired angle, and ensure
handle is secure between the teeth properly before
operation.
WARNING
the use, care and protection of grinding wheels.
Use grinding wheels, and accessories that are:
correct size as written on tool's nameplate.
•
rated at or above the RPM listed on the tool's
•
nameplate.
•
correct accessory, wheel type and grit for the job.
Grinding is the cutting action of thousands of
abrasive grains on the face of a grinding wheel.
When grinding metals such as steel and iron,
choose an aluminium oxide grinding wheel. Select
a silicon carbide grinding wheel for stone and
concrete.
non-ferrous metals.
6
Guard
Remove battery to avoid starting the
tool.
Always adjust the guard to provide
the
operator
Adjusting the Side Handle
Remove battery to avoid starting the
tool.
To reduce the risk of injury, the
operator should be instructed in
Grinding Wheel Selection
Use
cotton
reinforced
with
maximum
wheels
for
Advertisement
Table of Contents
