Replacing A Battery Temperature Sensor - Huawei MTS9300A User Manual

MTS9300A Telecom Power (Ooredoo, Indonesia,
MTS9304A-HD2002)
User Manual
Step 3 Disconnect the cable from the communications port on the sensor.
Step 4 Remove the faulty sensor.
Figure 4-13 Removing a sensor
Step 5 Set the DIP switch of the new sensor based on the recorded information.
Step 6 Put the new sensor on the side of the cabinet.
Step 7 Connect cables based on the recorded information.
----End

4.3.8 Replacing a Battery Temperature Sensor

Prerequisites
●
●
Procedure
Step 1 Connect the ground cable to the ESD wrist strap, and put on the ESD wrist strap
and ESD gloves.
Step 2 Remove the battery temperature sensor cable from the UIM.
Step 3 Cut off the cable tie of the battery temperature sensor and remove the sensor.
Do not touch the metal surface of the battery temperature sensor.
Issue 06 (2021-10-13)
You have obtained an ESD wrist strap, a pair of ESD gloves, an ESD box or
bag, the cabinet door key, and a tool kit.
The new battery temperature sensor is intact.
NO TICE
Copyright © Huawei Technologies Co., Ltd.
4 Maintenance
59