Picture Tube Removal Ceccccecsccceeeseseseesseecececscsceeeeeeeeereceeceeses; Removal Of Anode-Cap Ain Wledbeues Dovatedemiee Dhaedessekeedveveseesees Erences - Sony TRINITRON PVM-14N1A Service Manual

2-5. PICTURE TUBE REMOVAL
2. Connector panel
5. CA board (14 inch)
CB board (20 inch) Remove the two claws
20 inch only 14 inch only
3. PCBholder | Fo }}.} | |
6. Deflection yoke
7. Four screws
(Tapping screw 5) —@
8. Picture tube i SS
shield
2).
|
|
|
|
4. A board |
|
|
|
|
¢ INSTALLATION OF ANODE-CAP
Point
1. Insert a point of anode cap into FBT (a hole).
2. Confirm that it does not fall out even if the anode
1. Anode cap
cap is pulled.
Cap
Install in order of 3-+2—+1 as shown in the illustration
V below and confirm that it does not fall out even if the cap
i s pulled. | FBT is pulled
Cushion a
¢°REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, picture tube shield or carbon painted on the picture
tube, after removing the anode.
e REMOVING PROCEDURES
1. Turn up one side of the rubber cap 2. Using a thumb pull up the rubber cap 3. When one side of the rubber cap is
in the direction indicated by the arrow firmly in the direction indicated by the separated from the anode button, the
®, arrow ©. anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow ©.
e HOW TO HANDLE AN ANODE-CAP
1. Don't hurt the surface of anode-caps with sharp shaped material!
2. Don't press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the rubber.
3. Don't turn the foot of rubber over hardly! ,
The shatter-hook terminal will stick out or hurt the rubber.