Wolf E Series SO30-2F/S Installation Instructions Manual page 17

I N S TA L L AT I O N I N S T R U C T I O N S
I N S TA L L I N G T H E O V E N
M O U N T O V E N T O C A B I N E T R Y
Once the oven is fully inserted into the cabinet
opening, locate the mounting holes on the
oven side trim. There will be four mounting
holes for a single oven and six for a double
oven. Refer to the illustration below. Use a
drill bit to drill pilot holes into the cabinet.
Use the provided wood screws to secure the
oven to the cabinet through the oven
mounting holes.
Failure to install the mounting screws
may cause the oven to move or tip
forward during use. This may result in
damage to the oven or personal injury.
Location of mounting holes
O V E N O P E R A T I O N
IMPORTANT NOTE: Prior to operating the
oven, be sure to read the entire Wolf E Series
Built-In Ovens Use & Care Information
included with the oven for important safety,
1
/ " service and warranty information.
16
Unpack the box containing the oven compo-
nents found in each oven cavity. Install the
oven rack guides onto the shoulder screws
located on the interior side walls of the oven.
Slide the oven racks onto the support racks
within the oven. There are three racks per
oven. Place the broiler pan and grid on a rack
within the oven, if desired.
Turn on the power supply to the oven. Set the
time of day by pressing the CLOCK touch pad,
input the desired time by using the number
pads, then touch ENTER.
Select any of the ten cooking modes on the
control panel. Verify that the oven is coming
up to temperature. For the double oven, be
sure to verify operation of both ovens.
IMPORTANT NOTE: A small amount of smoke
and odor may be noticed during the initial
break-in period. Refer to the Use & Care
Information for additional information.
17